Since Mark asked about using the new modular Maha action figure body as a base for the third-party "red guard" inspired by the Emperor's Royal Guard from ROTJ, I gave it a quick test. It works, with some futzing. For once, I took all the progress photos, so here it is:
No problem sliding on the pants, the boots fit easily onto the ankle pegs (I left the added ankle extenders on). I chose not to use the padding for the torso, in part because it was difficult, in part because it was unnecessary.
The "tunic" zips up at the back, making it relatively easy to put on. The hands swap easily enough. The belt was a bit of a pain, because instead of velcro, it attaches with little hooks. The hole inside the helmeted head is a bit wide for the neck peg's upper ball joint. While one could theoretically seek another neck peg that would work at both ends, I lined the upper ball joint with some electrical tape, and got a slightly better fit. It could have been better, but I was working on a quick solution. Visually, it is irrelevant.
Here is the finished look. He stands about 31.10 cm tall.
A comparison to the Medicom and Hot Toys versions. Medicom is undersized, despite being upgraded to a better body in the reconstituted version you see here. Hot Toys is the same size as the custom. The custom's outer robe drapes a little less well and its red is a little less rich. However, depending on the light or if not side by side with the others, I think it works very well. So well, indeed, that I regretted not trying this out earlier, since now the set is sold out. Had I done so, I could have replaced both of my Medicom guards with the custom ones.
I hope this was helpful, to Mark and others.
As always, what do you think?
#starwars #rotj #Empire #imperial #royal #guard #scifi #fiction #custom
No problem sliding on the pants, the boots fit easily onto the ankle pegs (I left the added ankle extenders on). I chose not to use the padding for the torso, in part because it was difficult, in part because it was unnecessary.
The "tunic" zips up at the back, making it relatively easy to put on. The hands swap easily enough. The belt was a bit of a pain, because instead of velcro, it attaches with little hooks. The hole inside the helmeted head is a bit wide for the neck peg's upper ball joint. While one could theoretically seek another neck peg that would work at both ends, I lined the upper ball joint with some electrical tape, and got a slightly better fit. It could have been better, but I was working on a quick solution. Visually, it is irrelevant.
Here is the finished look. He stands about 31.10 cm tall.
A comparison to the Medicom and Hot Toys versions. Medicom is undersized, despite being upgraded to a better body in the reconstituted version you see here. Hot Toys is the same size as the custom. The custom's outer robe drapes a little less well and its red is a little less rich. However, depending on the light or if not side by side with the others, I think it works very well. So well, indeed, that I regretted not trying this out earlier, since now the set is sold out. Had I done so, I could have replaced both of my Medicom guards with the custom ones.
I hope this was helpful, to Mark and others.
As always, what do you think?
#starwars #rotj #Empire #imperial #royal #guard #scifi #fiction #custom
